Products:

Kromatica
Replica
Non-Precious
   Ceramic Alloys
Vest-All
SuperVest
SuperVest RF
SuperVest PC
High Fusing
   Solder Paste
Preformed Wax
    Sprues
Porcelite Kit

Replica



10 pound case consisting of 
ten 1 pound aluminum foil pouches and 1 empty can

Product No. Packaging
300-101 Cherry, Fast Set
300-105 Cherry, Normal Set
300-102 Mint, Fast Set
300-106 Mint, Normal Set
300-103 Bubblegum, Fast Set
300-107 Bubblegum, Normal Set
300-104 Non-Flavor, Fast Set
300-108 Non-Flavor, Normal Set


Twelve 1 pound containers per case

Product No. Packaging
300-121 Cherry, Fast Set
300-125 Cherry, Normal Set
300-122 Mint, Fast Set
300-126 Mint, Normal Set
300-123 Bubblegum, Fast Set
300-127 Bubblegum, Normal Set
300-124 Non-Flavor, Fast Set
300-128 Non-Flavor, Normal Set


20 pound Box consisting of
Twenty 1 pound aluminum boil pouches and 1 empty can

Product No. Packaging
300-201 Cherry, Fast Set
300-205 Cherry, Normal Set
300-202 Mint, Fast Set
300-206 Mint, Normal Set
300-203 Bubblegum, Fast Set
300-207 Bubblegum, Normal Set
300-204 Non-Flavor, Fast Set
300-208 Non-Flavor, Normal Set


50 pound Bulk

Product No. Packaging
300-501 Cherry, Fast Set
300-505 Cherry, Normal Set
300-502 Mint, Fast Set
300-506 Mint, Normal Set
300-503 Bubblegum, Fast Set
300-507 Bubblegum, Normal Set
300-504 Non-Flavor, Fast Set
300-508 Non-Flavor, Normal Set

Simple and easy to prepare.
Minimum body flow offers maximum patient comfort.
Patient pleasing cherry, mint and bubblegum flavors.
Dustless formula available.
Made in the U.S.A. and ADA approved.

Directions:
1. To obtain a proper powder measure, tumble canister to fluff the product. Scoop the powder and tap gently to eliminate voids and level off excess with spatula.

2. With room and materials at 73F (23C) this product will gel in approximately two minutes. Temperatures above 73F will decrease gel time, temperatures below 73F will extend gel time.

3. Mix thoroughly for 30 to 40 seconds until smooth consistency develops. Load impression tray.

4. Rinse patients mouth with warm water. Insert filled tray in the mouth. Hold for one minute after loss of stickiness.

5. Mixing ratio: 7 grams of powder to 20 milliliters of water.

6. For best model surface, wait 45 minutes before separating model from impression.

 

Kromatica        Replica        Non-Precious Ceramic Alloys        Vest-All        SuperVest        SuperVest RF
SuperVest PC        High Fusing Solder Paste        Preformed Wax Sprues       Porcelite Kit


Copyright 2003 All Rights Reserved.
Matech, Inc., 13000 San Fernando Rd, Sylmar, CA 91342 USA
ph. (800)292-6620          info@matechinc.com